Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Fit the dust bag in the dirt receptacle and
carefully position it against the container
wall and the container floor.
Fitting the safety filter bag
Illustration F
6. Fit the safety filter bag.
Illustration G
WARNING
your hands between the dirt receptacle and
filter ring or allow them to come close to the
lifting mechanism while locking it.
Lock the dirt receptacle by operating the
bow handle with both hands.
Illustration H
ATTENTION
DANGER
Respiratory sicknesses through inhalation
of dust.
No dusts harmful to health may be vacu-
umed when performing wet vacuum clean-
ing.
ATTENTION
Risk of damage if the dirt receptacle
overflows
The dirt receptacle can fill within a few sec-
onds and overflow when vacuuming large
amounts of liquids.
Continuously monitor the filling level.
1. Remove the dust bag or the safety filter
bag before wet vacuum cleaning (see
26
chapter Removing the dust bag/ safety
filter bag).
Removing the dust bag/ safety filter bag
2. Remove the suction hose if necessary.
receptacle (see chapter Closing the
suction connection).
Illustration C
4. Pull the bow handle up.
5. Pull the dirt receptacle out of the device
by the bow handle.
Removing the dust bag
Illustration I
6. Turn up the dust bag.
tie.
8. Remove the dust bag.
Removing the safety filter bag
Illustration J
10.Fold up the safety filter bag.
Illustration K
11.Peel off the protective film.
rear.
Illustration L
14.Seal the suction connection opening of
the safety filter bag tightly with the cover.
Illustration M
15.Close the safety filter bag tightly with the
attached cable tie.
16.Remove the safety filter bag from the
dirt receptacle.
17.Clean the interior of the dirt receptacle
with a moist cloth.
18.Dispose of the used safety filter bag in
dust-tight bag in accordance with statu-
tory regulations.
English
Werbung
Inhaltsverzeichnis
Fehlerbehebung
