Hauff-Technik MSH PolySafe Montageanleitung Seite 11

MSH PolySafe
Transport, packaging, scope of delivery and storage
Safety instructions in connection with transport
NOTICE!
Damage in the event of improper transport!
Significant damage can occur in the event of improper transport.
• When unloading packaging items on delivery and in the course of in-house
transport, proceed with care and observe the symbols on the packaging.
Transport inspection
Inspect the delivery immediately on receipt for completeness and transport da-
mage. In the event of transport damage being visible from the outside, proceed as
follows:
• Do not accept the delivery or only do so subject to reservations.
• Make a note of the extent of damage in the transport documentation or de-
livery note provided by the transporter.
• Submit a claim for every defect as soon as it has been identified.
• Claims for damages can only be asserted within the applicable claim
period.
Scope of delivery
The scope of delivery of the MSH PolySafe Multi-line building entry for buildings
with a basement GV1 includes:
• 1 Octagonal internal sealing element (sealing width 30 mm) with 4 sleeve pipes
DN75
• 8 Self-tapping screws 8x35 for line sealing
• 1 Test valve (pre-assembled)
The scope of delivery of the MSH PolySafe Multi-line building entry for buildings
with a basement GV2 includes:
• 1 Octagonal internal sealing element (sealing width 60 mm) with 4 sleeve pipes
DN75
• 8 Self-tapping screws 8x35 for line sealing
• 1 Test valve (pre-assembled)
The scope of delivery of the Modul 2 includes:
• 1 Outer flange with profile seal
• 4 Self-tapping screws 8x35
• 2 Spacers
The scope of delivery of the Modul 4 includes:
• 1 Fixed/loose flange for dowelling
• 4 Wall attachment elements SXR 10 x 80
• Modules 1, 1.2, 3, 6 and 6.2 are supplied without further elements.
Scope of delivery in the standard design! Deviations possible due to individual
combinations.
Storage
NOTICE!
Damage due to improper storage!
Significant damage can occur in the event of improper storage.
• The MSH PolySafe is to be protected from damage, damp and soiling prior to
installation. Only intact components may be installed.
• The MSH PolySafe must be stored in such a way that it is not exposed to low
temperatures (< 5 °C), high temperatures (> 30 °C) or direct sunlight.
Disposal
If no return or disposal agreement has been concluded, recycle dismantled com-
ponents after they have been properly dismantled:
• Metal remains are to be scrapped according to existing environmental regulati-
ons.
• Dispose of elastomers according to existing environmental regulations.
• Dispose of plastics according to existing environmental regulations.
• Dispose of packaging material according to existing environmental regulations.
Art. Nr.: 5090033075 Rev.: 05/2022-11-02 11