Adjusting The Speed - Maggi STEFF 2032 Betriebsanleitung

3-3 ADJUSTING THE SPEED

The selection of the feeding speed for
EN
the power feeder rolls closely depends
on the following information:
- type of machine tool (spindle
moulder, thicknesser planer, circular
saw)
- tecnical specifications
machine tool and its ratings
- speed of the tool
- diameter of the tool
- number of cutting edges
- quality of cutting edges
- hardness of the material to be removed.
- thickness of the material to be removed
- finishing surface of the feedstock
- surface of the material to be dragged
- hardness of the rubber roll
The speed must be selected by a
WARNING
skilled operator.
42
You can choose 4 different speeds
with the following adjustments:
1) Altering the revolutions of the
electric motor controlled by switch
(1 or 2).
2) Inverting transmission gears A and
B (Pos."1" or Pos."2").
of the
Motor
Pos. "1"
rpm
1 9 m/min
2 18 m/min
Fig.14
To invert transmission gears A and B
(Pos."1" or
follows:
1) Disconnected the power feeder
from the mains by removing its plug
from the electric socket.
2) Open the side door by unscrewing
the locking screw.
3) Unscrew the locking screws and
exchange the gears A and B .
4) Tighten the gear nuts and shut the
side door.
Pos. "2"
When this operation in over, make
4 m/min
8 m/min
sure the guard has been properly
tightened.
Pos."2") proceed as
WARNING