Maggi STEFF 2032 Betriebsanleitung Seite 40

WARNING
Verify that the working bench
onwhich the support
assembled is sturdy and stable.
The power feeder must be secured
onto the machine's main surface
and not onto surfeces considered
unstable (see Fig.8 - Fig.9 - Fig.10).
Make sure the locking handle (K)
that secures the vertical column to
the base has been
tightened (see Fig.7).
2-3 MOUNTING
FEEDER ON THE SUPPORT
base is Once the support has been fastened
to the workstand, one only needs to
attach the feeder unit by using the
specially-designed collar (M) (see
Fig.5) fitted at the end of the support.
Two screws are used: a tightening
screw (P) and a guide screw (Q); the
latter must not be tightened but only
properly
screwed over until it touches.
THE POWER
EN
39