Operation - Silvercrest SKPE 3 A1 Bedienungs- Und Sicherheitshinweise

˜ Operation
Do not operate the product for more than 5 minutes . Allow the
product to cool down before operating it again .
Choose a rubber collar
of the brush to be cleaned . The brush handle should fit tightly
into the rubber collar so it does not accidentally fall out .
Slide the brush handle into the round opening of the rubber
collar .
[ 9 ]
Slide the other end of the rubber collar
shaft . All parts are aligned in a straight line . Misalignment
1 ] [
may affect the performance of the product (fig . E) .
Place the brush into the bowl
not submerge the brush beyond the bristles (fig . F) .
Gently sweep the bristles against the bottom of the bowl
5 seconds .
Move the brush up and down in the liquid for 5 seconds .
Submerge the bristles (fig . G) .
Switch product on: Press and slide the I/0 switch
I position . The drive shaft
starts to spin . Allow to spin for 10 seconds . Move the brush up
and down in the liquid (fig . G) .
After 10 seconds lift the bristles above the liquid . Allow to
spin for a further 10 seconds, to dry the bristles (fig . H) . If the
bristles are still wet after 10 seconds, spin for an additional
10 seconds .
Switch product off: Slide the I/0 switch
which matches the handle diameter
9 ] [
, submerging the bristles . Do
7 ] [
, and therefore the attached brush,
1 ] [
onto the drive
9 ] [
to the
3 ] [
to the 0 position .
3 ] [
GB/IE
for
7 ] [
37