Cleaning And Care - Silvercrest SKPE 3 A1 Bedienungs- Und Sicherheitshinweise

˜ Cleaning and care
NOTES:
Clean the bowl
If necessary to remove residue soap liquid or cleanser: Rinse
the bowl
[ 7 ]
detergent . Note the MAX marking on the bowl (fig . D) .
Perform the steps listed in "Operation" but using clear water
until you reach a satisfactory result .
Switch off the product before cleaning and care .
Do not use any corrosive or abrasive cleaning agents . These
might damage the surface of the product .
Do not pour boiling water into the bowl
Switch product off: Slide the I/0 switch
Wipe down the main unit
Remove the splash guard
Cleaning the stand
collar : Rinse and wipe these parts with clean water when
9 ] [
necessary . Allow to dry completely .
Use the provided stand
product (fig . J) .
and splash guard
7 ] [
and fill the bowl with clear water without any
2 ] [
8 ] [
, bowl
5 ] [
to store the rubber collars
5 ] [
after every use .
[ 8 ]
.
7 ] [
to the 0 position .
3 ] [
with a dry cloth .
from the bowl
7 ] [
, splash guard
7 ] [
(fig . I) .
, rubber
8 ] [
and
9 ] [
GB/IE 39