Start - Starter Aid (If Foreseen); Procedure; Alarms - Telwin DOCTOR CHARGE 30 Gebrauchsanweisung

EXIT ADVANCED FUNCTIONS
3"

4.5 START - STARTER AID (if foreseen)

START mode (fi g. B.5) is available for 12V batteries
and supplies 70A current as a starter aid. If the
battery is completely run down, it is advisable to
perform a precharge cycle before proceeding.
ADVANCED FUNCTION SELECTION
3"
BEEEP
WAIT FOR 3" TO GET CONFIRMATION

4.5.1 Procedure

- Press and hold the button (fi g. B.1) for 3 seconds
to access the advanced program mode.
- select the START function (fi g. B.5) and wait for
the audible confi rmation signal;
- use the button (fi g. B.1) to select the battery
voltage;
- connect the clamps to the vehicle battery
terminals;
- now start the vehicle; a 30 second timer will
engage, accompanied by an audible beeping,
at the end of which it will be possible to start the
engine again;
- disconnect the clamps from the battery terminals.
- press the button (fi g. B.1) to exit the advanced
programs function mode.
BEEEP
ADVANCED
FUNCTIONS
Info
Alarm
DISPLAY
EXIT ADVANCED FUNCTIONS

4.6 ALARMS

The alarms are displayed by a graph symbol (fi g. B
.3) when there is a:
- polarity inversion;
- short circuit;
- battery voltage incompatible with operator's
choice;
- Pulse Tronic charge: start of maximum time for
phases 1, 2, 3 Check, Desulfation, Analyze;
- Pulse Tronic charge: charge loss in phase 6 Verify;
- Faulty battery.
INFO ALARM
- 70 -
SHORT CIRCUIT
POLARITY REVERSAL