Pulse-Tronic Charge; Setting Battery Voltage; Voltage Selection; Charge Function Modes - Telwin DOCTOR CHARGE 30 Gebrauchsanweisung

8. "SILENT NIGHT" function.
9. EQUALIZATION mode.
10. DESULFATION mode.
11. Choice of the battery production technology:
WET: lead-acid batteries with liquid electrolyte;
GEL: lead-acid batteries, sealed, with solid
electrolyte;
AGM: lead-acid batteries, sealed, with electrolyte
on absorbent material;
PbCa: lead-calcium batteries.
12. SUPPLY mode.
13. DIAGNOSTIC mode.
14. PULSE TRONIC charge process phases.
15. START mode (if present).
16. Automatic charge mode.
17. PulseTronic charge.
18. Recharge circuit function tests (alternator).
19. Battery starting capacity test.
20. Battery charge status test.
21. VOLT - Settings button:
- battery voltage 6/12/24V.
- silent mode.
- voltage/Ah regulator.
22. FUNCTION - Settings button:
- Pulse Tronic CHARGE (AUTO, AUTO , WET,
GEL, AGM, PbCa).
- TEST (battery status, vehicle alternator, battery
starting capacity).
- Advanced Programmes
EQUALIZATION, DIAGNOSTIC, SUPPLY).
- voltage/Ah regulator.
23. MODE - Settings button:
- output current (AUTO, BOOST, customised);
- START mode (if present).

3.2 SETTING BATTERY VOLTAGE

Use the "VOLT" button (fi g. A.21), to set the rated
voltage for the battery (fi g. A.1) to be charged.

VOLTAGE SELECTION

After connecting the clamps to the battery terminals:
- if the value detected is higher than the set value
(fi g. A.1), an "AL.2" error message (fi g. A.2) is
displayed;
- if the value detected is lower than the set value,
the display (fi g. A.1) starts to fl ash for 5 seconds
giving time to change the voltage value displayed
in (fi g. A.1).
NOTE. The no battery connected status is indicated
(DESULFATION,
DISPLAY
by the fl ashing (fi g. A.5) symbol.

3.3 PULSE-TRONIC CHARGE

3.3.1 CHARGE FUNCTION MODES

There are various Pulse Tronic charge procedures
that depend on the battery construction technology
(T) and the charge current (C). When the battery is
charged, the battery charger switches automatically
to maintenance mode.
BATTERY TYPE SELECTION
DISPLAY
CURRENT SELECTION
a) AUTOMATIC PULSE-TRONIC
(T) AUTO
Both the identifi cation of the battery construction
technology (fi g. A.16) and the current needed to
charge it function in automatic mode (fi g. A.6). This
function mode is recommended when there is no
information on the battery type.
b) AUTOMATIC
TEMPERATURES ( fi g. A.7)
(T) AUTO
Mode that improves the battery charge when the
temperature is very low. Low temperature can
infl uence the chemical structure of the battery
components, therefore this function optimises
the charge process according to this reduction in
temperature.
This feature applies to the WET, AGM, PbCa
batteries only.
When the battery is charged, the battery charger
switches automatically to maintenance mode.
- 59 -
AUTOMATIC
AUTOMATIC
WINTER T<0°C
MANUAL
DISPLAY
AUTOMATIC
QUICK CHARGE
Ah
MANUAL
(C) AUTO
PULSE-TRONIC
(C) AUTO
AT LOW