Inspection And Maintenance Work; Wash The Filter; Changing/ Replacing Filter - Kärcher IVS 100/40 M Bedienungsanleitung

CAUTION
Risk of damage! Do not use detergents containing sili-
cone to clean.
– No outside help is required for carrying out basic
maintenance and cleaning.
– The appliance surface and the inside of the con-
tainer should be cleaned regularly using a damp
cloth.
DANGER
Risk due to dust hazardous to health. Always use dis-
posal clothing and P2 or higher breath-safe masks while
carrying out maintenance tasks (such as changing fil-
ters).

Inspection and maintenance work

Have the vacuum cleaner regularly inspected according
to the respective national accident prevention regula-
tions.
Maintenance work must be carried out by a specialist at
regular intervals in accordance with the specifications of
the manufacturer. The existing stipulations and safety
requirements are to be here observed. Work on the
electrical plant may only be carried out by qualified elec-
tricians.
If you have any more questions, your KÄRCHER
branch will be happy to help.
Maintenance intervals / user maintenance
No periodic maintenance intervals are specified for this
device. The following maintenance is to be performed
as necessary:


Wash the filter.

 Change the filter.
 Replace the filter.
Wash the filter
The filter can be washed out under running water.
ATTENTION
Risk of damage! Do not use washing agents or bleach.
Only insert the filter into the appliance when it is com-
pletely dry.

Changing/ replacing filter

CAUTION
Health risk from dust escaping. Changing the filter must
be done in a suitable maintenance area. Wear protec-
tive gear when changing the filter.
Dispose of the old filter according to the legal regula-
tions.
18
1 Lid of filter chamber
2 Filter spreader
3 Washer ring
4 Filter
 Remove the hose clamp on the connection hose.
Use a screwdriver.
 Open locks.
 Remove the lid of the filter chamber.
 Pull the new dust bag over the filter chamber and
the inserted filter.
 Pull the filter into the dust bag and out of the device.
 Close and dispose of the dust bag.
 Thoroughly clean the outside of the device before
inserting a new filter by vacuuming it and wiping
with a damp cloth.
 Check sealing ring for damage.
 Insert the new filter in reverse sequence and take
care to ensure that the filter spreader is aligned cor-
rectly in the filter bag.
– 7
EN