Kärcher IVS 100/40 M Bedienungsanleitung Seite 15

Start up
WARNING
Do not vacuum without the filter elements; otherwise,
the suction motor can get damaged and this can be haz-
ardous to health on account of increased release of fine
dust particles.
 Bring the device into the working position and lock
parking brake.
 Insert the suction hose into the suction hose con-
nection.
 Attach the desired accessoried to the suction hose.
 Ensure that the vacuum material container has
been inserted properly.
 Check the fill level in the dirt container prior to start-
ing work and empty the container if necessary.
Warning
The highest allowed net impedance at the electrical
connection point (refer to technical specifications) is not
to be exceeded.
In case of confusion regarding the power impedance
present on your connection, please contact your utilities
provider.
Operation
The device is suitable for vacuuming fine dust up to dust
class M. Use a dust bag when vacuuming this dust
class.
Conventional vacuumed material (wet/dry) can be vac-
uumed directly into the vacuum cleaner waste container
without a dust bag.
After vacuuming moist or liquid substances, observe the
notes in chapter "Changing from wet vacuuming to dry
vacuuming".
CAUTION
Never remover the filter when vacuuming.
– The device is equipped with a dust bag, order no.
9.989-607.0 (5 pieces).
Note: All types of dust up to dust class M can be vacu-
umed with this device. The use of a dust collection bag
(for order no., see label on the device) is required by
law.
Note:The appliance is suited as industrial vacuum
cleaner to take up dry, non-combustible dusts with MAK
values greater than or equal to 0.1 mg/m
ATTENTION
Remove the dust bag before wet vacuum cleaning.
Installing the dust disposal bag
 Lock parking brakes.
 Unlock and lower the container.
 Pull the container out by the handle.
 Insert the disposal bag so that it is snug against the
 Pull disposal bag over the container.
 Reinsert container and lock.
Removing the dust disposal bag
 Lock parking brakes.
 Unlock and lower the container.
 Switch on device to avoid releasing dangerous
 Pull the container out by the handle.
 Put the disposal bag over.
.
3
 Tightly seal the disposal bag with closure strips un-
 Remove disposal bag.
 Dispose of the disposal bag according to the local
 Reinsert container and lock.
– 4
EN
Disposal system
reservoir wall and the reservoir bottom.
dusts.
derneath the opening.
provisions.
15