Menüpunkt Restart - Siemens SIMATIC NET SCALANCE W744-1PRO Betriebsanleitung

Configuration Using Web Based Management and the Command Line Interface
6.2.4 Restart Menu Command
Restart button
Click this button to restart the SCALANCE W74x. During a restart, the
SCALANCE W74x is reinitialized, the internal firmware is reloaded, and the
SCALANCE W74x runs a self-test. The entries that have been learned in the
address table of the SCALANCE W74x are deleted. You can leave the browser
window open while the SCALANCE W74x restarts.
Restore Memory Defaults Button
Click this button to reset the configuration. The following parameters (protected
defaults) are not restored:
● IP address
● Subnet mask
● Gateway address
● IP address of the default router
● DHCP flag
● System name
● System location
● System contact
● Device mode
● Country code
There is no automatic restart. This allows you to enter data using Web Based
Management before the restart. The changes take effect only after a restart.
If you are logged on as user, the Restore Memory Defaults button is not visible.
Operating Instructions SCALANCE W744-1PRO / SCALANCE W746-1PRO / SCALANCE W747-1RR
90
C79000-G8976-C185-06