Overview - VOLTCRAFT VC611BT Bedienungsanleitung

Rotary control for selecting the measuring function
• V / ~ (measure DC / AC voltage in the unit volt)
• Ω / (measure resistance, buzzer on / off, diode)
• (measure capacitance)
• Hz (measure frequency)
• ºC (temperature in the unit ºC)
• ºF (temperature in the unit ºF)
• µA / ~ (Measure DC / AC current in the unit micro ampere)
• mA / ~ (Measure DC / AC current in the unit milli ampere)
• A / ~ (Measure DC / AC current in the unit ampere)

7. OVERVIEW

The multimeter (referred to as DMM in the following) indicates measured values on a digital display.
The measured value display of the DMM comprises 6000 counts (count = smallest display value).
If the DMM is not operated for approx. 10 minutes, the device switches off automatically to save
power.
The meter can be used for do-it-yourself or for professional applications up to CAT II.
The user will not be notified via acoustic warning signal or display if the test leads are connected
incorrectly. It is therefore imperative that you make sure you have chosen the correct test sockets for
the selected measuring function before starting measuring.
The individual measuring functions are selected via a rotary control. The automatic range selection
"AUTO" is active for some measuring functions. The appropriate range of measurement is set
individually for each application. Always start current measurements at the highest measurement
range (10 A) and switch down to lower ranges if necessary.
Use the on/off switch (15) on the back to turn the device on and off when operating on the grid (230
V/DC). When running on batteries, the BAT/AC switch (14) must be set from BAT to AC and the on/
off switch (15) to off in order to turn off the device before the automatic switch-off. Always turn off the
device when it is not in use.
41