Troubleshooting; Safety Notes For Troubleshooting - Linde V200 Gebrauchsanleitung

9. TROUBLESHOOTING

The following section describes possible causes of malfunction and how to eliminate them. If malfunctions
occur with increasing regularity, shorten the maintenance intervals to refl ect the actual load. If malfunctions
occur that cannot be eliminated with the following help, please contact the manufacturer.

9.1. SAFETY NOTES FOR TROUBLESHOOTING

In any case of malfunction, the shut-off valves oft he connected gas cylinder, gas container or bundle must
be closed. Never operate devices with malfunctions under pressure.
WHAT TO DO IN CASE OF MALFUNCTION:
1. Interrupt and ensure gas supply.
2. Depressurize pressure regulators and close valves.
3. Only trained technical staff may eliminate malfunctions.
4. Restore component to its original state.
Description Reason
No Flow Pressure
(Inlet Gauge Regulator is
shows pres- closed
sure, outlet
gauge not)
No Flow (Inlet Cylinder Valve
and Outlet closed Pro-
Gauge show cessgas Valve
„0") closed Pres-
sure Regulator
closed Cylin-
der coil/ hose
not connected
No Flow Handwheel
closed
Increase of Leakage in
outlet pressure pressure regu-
& relief valve lator seat
opens
Slight increase Inlet pressure
of outlet pres- drop
sure & relief
valve does not
open
Slight increase Diff erence
of outlet pres- between fl ow
sure pressure (with
gas fl ow) and
Zero Pressure
(without gas
fl ow)
Solution Valve
Open pressure
regulator slowly
Close purge
valve
Initial Start- Up
see point 6
Installation and
initial start-up
Open hand-
wheel slowly
Repair by
manufacturer
No failure, nor-
mal operating
state
No failure, nor-
mal operating
state
17/294
Cylinder Line Gas
Regulator Regulator Supply Panel
EN