Pull-Cord Installation - newgen medicals MS198301 Benutzerhandbuch

EN

Pull-cord Installation

B
A
C D
There are two pull-cord loops located by the handles near the base on either
side of the 7 in One Power Trainer. Pull the ends of the pull - cords together
and pass them through the pull-cord loops at the base of the 7 in One Power
Trainer. When you pass the base of the pull-cord through the pull-cord loops,
then pass the pull- cord's handle through the loop at the base of the pull-cord,
you will have successfully fastened the pull-cord to the device. When using the
device, ensure that the pull-cord is securely fastened to the pull-cord loop.
Prior to using the 7 in One Power Trainer make sure that the fixed knot is
secure and that the pull-cord ring and pull-cord are tightly coupled together.
Regularly inspect the pull-cord. If it shows any signs of wear and tear or is
worn or damaged, do not use it.
1 1