Honeywell Miller H-Design DuraFlex Bedienungsanleitung Seite 18

of the locking system,

If it has a manual locking system, do not attach and remove it several times during a
working day
SIMILARLY, IF THE CARABINER HAS BEEN USED TO ARREST A FALL, IT IS NECESSARY
FOR THE SAKE OF SAFETY, TO RETURN IT FOR CHECKING.
The attachment of the fall arrest system to the harness MUST BE MADE SOLELY by the back
attaching element provided for the purpose ("D" link or webbing attaching extension) (cf. III))
or by chest anchorage points (webbing links or "D" link) (cf. IV & V). The chest attaching web-
bing points must imperatively be used with two points at the same time. When connecting a
shock-absorbing lanyard to the dorsal extension strap on the harness, ensure that the total
length of the lanyard + extension strap + connector does not exceed 2m. When connecting a
shock-absorbing lanyard to the dorsal extension strap on the harness , ensure that the total
length of the lanyard + extension strap + connector does not exceed 2m.
During use, check the adjusting and/or attaching parts from time to time.
SPACE CLEARANCE
If there is a risk of falling, or if anchorage can only be provided below the attaching points
of the harness, it is essential to use a lanyard fi tted with an energy absorber Before using an
energy absorber incorporated into a lanyard, check for a minimum space clearance below the
user's feet as necessary, to prevent any collision with the structure or the ground (please refer
to the corresponding user instruction). With a weight of 100 kg and a fall factor of two (worst
case scenario), the air clearance D is the stopping distance H (2L+1.75m) plus an additional
distance of 1 m. (cf. VIII). Important: if the harness is equipped with an extension strap, take this
into account when calculating the clearance distance.
3 2 WARNING
Park points can resist to a load of 2 kg. If the load connected to these park points exceed the
maximal load or if you pulled down sharply on the park point ring, the ring will then come off
the plate. If the ring comes off the plate, it is still possible to attach it back to the plate without
any impact on the safety of the harness reliability.
For a fall arrest harness to be totally effi cient, it must be properly adjusted (cf II-IV)
3 3 EMERGENCY PROCEDURES
"whenever a fall protection system is used, a plan must be established to deal with any emer-
gency that may happen (eg a rescue after a fall)"
4 AFTER USE INFORMATION
4 1 CLEANING

The harness should be cleaned with water and a mild soap (neutral PH). Never use acid,
solvents or any solvent-based product,

Leave to dry in a well-ventilated area, away from sources of heat. Store the harness away
from humidity and ultraviolet light,

Avoid any atmosphere that is corrosive or excessively hot or refrigerated.
4 2 PERIODIC EXAMINATION
These instructions must be kept with the product. Fill in the identifi cation sheet and enter
the markings information. This periodic examination, which verifi es the effectiveness and
strength of the equipment is indispensable in guaranteeing the user's safety. It is your res-
18