Honeywell Miller H-Design DuraFlex Bedienungsanleitung Seite 17

made of elasticised webbing require a tighter fi t.
Once your harness is adjusted, check that no webbing is twisted or crossed over, that all the
buckles are correctly attached and that the back 'D' is situated at the level of the shoulder
blades. For optimum safety, do not hesitate to seek help.
2 5 HOW TO TAKE OFF THE HARNESS
After work, once there is no risk of fall from height anymore, unlock the different buckles to
take off the harness.
3 USE
3 1 USE INFORMATION
To correctly attach the fall arrest harness to an anchorage point (compliant with EN 795) and
make sure that the work will be performed in a way that it minimizes as much as possible the
risk of fall and reduces the work height, we recommend that you proceed as follows:

To connect an energy absorber (compliant with EN 355) to the back attaching element
of the fall arrest harness ( cf. EN 355) or an automatic retractable fall arrester (compliant
with EN 360).

For the chest attaching element of the fall arrester of the harness, connect a mobile fall
arrester which includes an anchorage support (rigid compliant with. EN 353-1, flexible
compliant with EN 353-2).
ANCHORAGE POINT
If possible, to be used with anchorage devices (conformed to the EN 795 standard - please
refer to the corresponding user instruction) or structural anchor. that is to say elements fi xed
to last to a structure (wall, post...).
Check that the anchorage point:

Offers minimum resistance of 12 kN,

Is situated ideally above the operator, (cf. X).

Is vertically in line with the working surface: (maximum angle ± 30°),

Is totally suited to the equipment attaching device

Has no sharp edges
CARABINER
Connector is compliant with EN 362 standard

The carabiner must be connected directly to the harness with no intermediary buckle.

When the carabiner is used for attachment to an anchorage point, check for compliance
with the recommendations of the «ANCHORAGE POINT" paragraph.
It is also possible to use a webbing anchor point (EN 795) or an anchoring clamp (EN 362)
to attach oneself to an anchorage point.
WHEN CONNECTING THE CARABINER, MAKE SURE THAT THE LOCKING SYSTEM IS IN
CAUTION:
The carabiner is an essential component for your safety (please refer to the corresponding
user instruction). We therefore advise you to:

Assign the connector to a single person where possible,

Check before each use for any signs of deformation or, wear and for the correct operation
PLACE.
17