Herunterladen Inhalt Inhalt Diese Seite drucken

Honeywell Miller H-Design DuraFlex Bedienungsanleitung Seite 16

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 26
AND ULTRAVIOLET LIGHT,
Avoid any atmosphere that is corrosive or excessively hot or refrigerated.
During transport, check that your PPE is stored well away from any source of heat, damp,
corrosive atmosphere, ultraviolet rays, etc. ...
2 2 HOW TO SELECT THE APPROPRIATE SIZE
(CF. P 3)
2 3 CHECKING
Before each use, carry out a thorough visual examination to ensure that the PPE, as well as
any other equipment that may be attached to it (connector, lanyard, etc.) is complete. Make all
necessary arrangements for the implementation of any rescue in total safety. In the event of
your product being damaged, consult the manufacturer or his agent. If you have any doubts
regarding the safe condition of the product, or if the product has been used to arrest a fall, it is
essential to your personal safety that the PPE be withdrawn from service and sent back to the
manufacturer or a qualifi ed repair centre for checking, or destruction. Following examination,
the centre will either deliver or refuse written authorisation to re-use the PPE. It is strictly for-
bidden to modify or repair a PPE yourself. Only the manufacturer or a repair centre is qualifi ed
to carry out these repairs.
Check the serviceable condition of the harness: (cf.VII) :
No incipient breaks in the webbing,
No deformation of the D-links,
Correct operation of the buckle systems,
Integrity of the seams,
Good condition of the metal components.
The non-tripping of the fall indicators
Your harness may have several fall indicators :
On the back plate (where the back D-Ring is) : if this fall indicator is triggered, an element
of the back plate will break.
On the front webbing loops (front attachment webbing points) : if this fall indicator is
triggered, the red stitching on each chest webbing loops will break. A fall indicator will
then be visible (warning label indicating that the product should not be used anymore)
On the chest strap (chest attachment point via one D-Ring) : if this fall indicator is trigge-
red, the red stitching on the chest strap will break.
2 4 PUTTING AND ADJUSTMENT ON THE FALL ARREST HARNESS
Please proceed as follows in order to put your harness on without diffi culty (cf. I):
Take the harness by the Back 'D' ring,
Put on the shoulder straps one after the other,
Pass the thigh straps between your legs, in order to lock them into the buckles on either
side of your hips. Be careful not to cross the thigh straps
Adjust the thigh straps by pulling or releasing the strap end (cf. G)
Close the chest strap,
Adjust the front adjustment buckles one after the other by pulling on or releasing the end
of the strap. (cf. I)
Adjust the chest straps horizontally by pulling on or releasing the end of the strap, or
vertically by pulling the park points up or down (depending on the harness model).
For a fall arrest harness to be totally effi cient, it must be properly adjusted (not too tight or too
loose, and thigh straps must be in a horizontal position on the legs). Please note: harnesses
16

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Miller h-design

Inhaltsverzeichnis