Electrical Safety; Assembly And Adjustments - DeWalt DC800 Originalanweisungen

E N G L I S H
Battery problem
Discard the battery pack with due care
for the environment
Do not incinerate the battery pack
Charge only with dedicated D
chargers
Package Contents
The package contains:
1 Cordless impact wrench
1 Battery pack (DC800K/DC810K)
2 Battery packs (DC800KL/DC810KL)
1 Charger
1 Kitbox (K-models only)
1 Instruction manual
1 Exploded drawing
NOTE: Battery packs and chargers are not included
with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fi g. A)
WARNING: Never modify the power tool
or any part of it. Damage or personal
injury could result.
1 On/off switch
2 Tool holder
3 Pistol grip
4 Forward/reverse button
5 Battery pack
6 Release button
7 Charger
8 Charging indicators (red)
INTENDED USE
These DC800/DC810 impact wrenches are
designed for professional screwdriving and
nutsetting applications.
32
DO NOT use under wet conditions or in presence of
fl ammable liquids or gases.
These heavy-duty impact wrenches are professional
power tools.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators
use this tool.

Electrical Safety

The electric motor has been designed for one voltage
WALT
E
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger
corresponds to that of your mains.
Your D
in accordance with EN 60335; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the
plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made
to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is 1
2
mm ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only D
packs and chargers.
WALT charger is double insulated
E
WALT battery
E