Package Contents; Electrical Safety; Using An Extension Cable - DeWalt DCF836 Bersetzt Von Den Originalanweisungen

Discard the battery pack with due care
for the environment.
Charge D WALT battery packs only with
e
designated D WALT chargers. Charging
e
battery packs other than the designated
D WALT batteries with a D
e
charger may make them burst or lead to
other dangerous situations.
Do not incinerate the battery pack.

Package Contents

The package contains:
1 Impact driver
1 Charger
1 Magnetic bit holder
1 Belt hook
1 Kitbox
1 Li-Ion battery pack
(C1, D1, M1, P1, S1 models)
2 Li-Ion battery packs
(C2, D2, M2, P2, S2 models)
3 Li-Ion battery packs
(C3, D3, M3, P3, S3 models)
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (Fig. 1, 2)
WARNING: Never modify the power
tool or any part of it. Damage or personal
injury could result.
A. Trigger switch
B. Forward/reverse button
C Chuck collar
D. 6.35 mm (1/4") hex quick-release chuck
E. Battery release button
F. Battery pack
G. Worklight
H. Belt hook
I. Screw
J. Magnetic bit holder
K. Main handle
L. Fuel gauge
INTENDED USE
These impact drivers are designed for professional
impact screwdriving applications. The impact
function makes this tool particularly useful for driving
fasteners in wood, metal and concrete. DO NOT
use under wet conditions or in the presence of
flammable liquids or gases.
WALT
e
These impact drivers are professional power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
e
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.

Using an Extension Cable

An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
Your D WALT charger is double insulated
e
in accordance with EN60335; therefore
no earth wire is required.
WARNING: No connection is to be
made to the earth terminal.
english
35