Malfunctions - Causes And Elimination - Soehnle Professional 6730 Gebrauchsanweisung

10. Malfunctions - causes and elimination

Read the following troubleshooting instructions before contacting service personnel.
Error
The scale cannot be switched
on when using the rechargeable
battery.
Battery cannot be switched on.
The scale cannot be switched
on when using the rechargeable
battery.
Does not turn on when the
rechargeable battery is used.
Displayed weight questionable
or scale does not reset to zero.
„STOP" message is shown in
the display.
Message „---" is shown in the
display.
"LO Bat" is shown in the display. Rechargeable battery is weak.
Error list
Error
SAT
RTC
If the errors cannot be eliminated or if other error messages are displayed, please contact your
your service partner.
46
Possible cause
Battery discharged.
1. Battery discharged
2. Mains socket defective
3. Power supply defective
1. Weight display is falsified by
falsified by object
2. The weighing pan is not correctly
positioned
3. Before weighing, the display
did not show 0.0 „lb/kg was not
displayed before weighing
4. Scale is not stable
5. Scale no longer correctly
calibrated
Load exceeds the capacity of the
scale.
Scale is in underload condition
Definition
A/D Saturation
Real time clock reading error
Remedial action
Connect the scale to the power
source.
1. Replace batteries
2. Use other power outlet
3. Replace power supply
1. All objects / infant
from the weighing pan
2. Arrange weighing pan correctly
3. Remove infant from weighing pan,
Set scale to zero and weigh again
4. Place scale on stable surface
and repeat weighing procedure
5. Check weight with object of
with known weight
Remove excessive weight and
Observe maximum load values.
Check that the weighing pan
on the base.
Recharge the battery
recharge.
Check / Replace
Check charging cell
- CALL IN TECHNICIAN
Battery of the real-time clock empty
or circuit board defective
- CALL IN A TECHNICIAN