Package Contents - DeWalt DC222 Originalanweisungen

1. Take off the protective battery cap (n) before
placing the battery pack in the charger
or tool.
2. Place the protective cap over the contacts
immediately after removing the battery pack
from the charger or tool.
WARNING: Make sure the protective
battery cap is in place before storing or
carrying a detached battery pack.
Battery Pack (fi g. 1)
BATTERY TYPE
The DE0241 and DE0243 operate on 24 volt battery
packs.
Storage Recommendations
1. The best storage place is one that is cool and
dry away from direct sunlight and excess heat
or cold. For optimum battery performance and
life, store battery packs at room temperature
when not in use.
2. Long storage will not harm the battery pack or
charger. Under proper conditions, they can be
stored for up to 5 years.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
Read instruction manual
before use.
Battery charging.
Battery charged.
Problem charging.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Use only with D WALT battery packs,
E
others may burst, causing personal injury
and damage.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 °C and 40 °C.
Discard the battery pack with due care for
the environment.
Do not incinerate the battery pack
NiMH, NiCd+ and Li-Ion.
Charges NiMH and NiCd
See technical data for charging time.

Package Contents

The package contains:
1 Cordless rotary hammer drill
1 Side handle
1 Depth adjustment rod
1 Charger (K-models only)
2 Battery packs (K-models only)
1 Kitbox (K-models only)
1 Keyless chuck (DC224)
1 Instruction manual
1 Exploded drawing
NOTE: Battery packs and chargers are not included
with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Variable speed switch
b. Forward/reverse slider
c. Mode selector
d. Safety lock
e. Tool holder
f. Locking collar
g. Dust cover
h. Depth adjustment rod
EN GL IS H
37