Startup / Operation - BOMANN KS 7230.1 Bedienungsanleitung, Garantie

WARNING:
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reversing the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
screw wrench, Phillips screw-
• Loosen the screws (1) on the appliance back.
Remove the cover caps (2), loosen the screws
underneath and remove the appliance cover.
• Dismount the upper door hinge (3) and lift the
appliance door. Displace the door cover plug (4)
and set the appliance door safely aside.
• Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet (5) and (6). Dis-
assemble the lower door hinge (7).
• Transfer and attach the lower door hinge (7) to
the opposite appliance side. Screw in the feet (6)
and (5) accordingly.
• Put the appliance back in the upright position.
Put on the appliance door and fix it its intended
position.
• Transfer and attach the upper door hinge (3) to
the opposite appliance side.
• Fasten the appliance cover and replace the cover
caps (2).
Check that the door is optimally aligned both vertical-
ly and horizontally to ensure a smooth opening and
closing of the door.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and Maintenance".
the chapter
20