Operation; Heat And Blower Levels - Silvercrest SHTK 2000 A1 Bedienungsanleitung

Operation

NOTE
► Before use, pull the plug out of the device up to the point indicated with a
red mark!

Heat and blower levels

1) Insert the plug into a power socket.
2) Switch the hair dryer on with the blower level switch 5.
The hair dryer is fitted with two function switches. With these you can separately
select the strength of the air flow (blower level switch 5) and the level of heat
(heat level switch 6):
Blower levels
0
Heat levels
3) After use, switch the appliance off in that you place the blower level switch 5
into position "0". Then remove the plug from the wall socket.
4) Press the cord retract button
SHTK 2000 A1
The hair dryer is switched off
reduced air flow
full power air flow
cold air flow
low heating level
high heating level
2 to feed the cord back into the device.
GB │ IE │ 7 ■