Hanging The Hood Onto The Wall; Installing The Hood Flue; Flue Connection - Beko HCA63640B Bedienungsanleitung

5 Installation of appliance
3.9x22 Cross-
4.9x50 Cross-
head screw
head screw
(Figure 3)

5.7 Hanging the hood onto the wall

• Hang the hood onto the screws you have in-
stalled into the Y holes.
• Open the side suction window of the hood by
pulling it towards yourself. Install the 4.9x50
screws through the X holes located inside in
order to secure the appliance.

5.8 Installing the hood flue

Disconnect the product from mains supply before
starting flue installation. Fit the sheet metal flue
parts around the body.
Screw the external flue to the external flue con-
nection plates located on the motor housing.
(Figure 1b/4)
(Figure 4)
Cooker Hood / User Manual
Extend and screw the internal flue from its outer
edges onto the flue connection plate which was
Z
secured to the wall (Figure 5).
Z
Y
X Y
X
(Figure 5)

5.9 Flue connection

Place adapter supplied together with the hood
into the ventilation hole located on the top sec-
tion of the hood. Procure a pipe with a diameter of
120/150 mm. Connect one end of the pipe to the
adapter and the other end to the flue. Make sure
that these two connections are secure enough so
that they will not dislocate when the hood is op-
erated in max. speed. Check that the flaps inside
flue are functional when tightened with the clamp.
Fit the flue connection pipe onto the adapter. If you
fit the flue connection pipe inside the adapter, air
suction will not occur since the flaps that prevent
air backflow will remain closed. It is not advisable
to make connections to the flues connected with
stoves or exhaust shafts. Do not make connections
to such flues. Pipe connection must be as short
as possible and have minimum number of elbows.
A: Flue outlet pipe
B: Flaps that prevent backflow
C: Plastic flue
15 / EN