Specifications - Makita LC1230 Betriebsanleitung

ENGLISH
(Original instructions)
1 Hook
2 Bolt
3 Lock-off button
4 Lever
5 Handle
6 Switch trigger
7 Graduation
8 Indicator
9 Vise stop

SPECIFICATIONS

Model
Blade diameter .................................................................................................................................................... 305 mm
Hole (arbor) diameter ......................................................................................................................................... 25.4 mm
-1
No load speed (min ) ............................................................................................................................................. 1,300
Dimensions (L x W x H) .........................................................................................................516 mm x 306 mm x 603 mm
Net weight ............................................................................................................................................................19.3 kg
Safety class ............................................................................................................................................................
Cutting capacity
Workpiece shape
Cutting angle
90°
45°
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in mild steel and stainless
steel with appropriate saw blades.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
8
Explanation of general view
10 Dust box
11 Wrench holder
12 Base
13 Center cover
14 Hex bolt
15 Socket wrench
16 Blade guard
17 Shaft lock
18 Carbide-tipped saw blade
115 mm
90 mm
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
ENE008-1
operation of other equipment. With a mains impedance
equal or less than 0.25 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.
ENF002-2
General Power Tool Safety Warnings
instructions. Failure to follow the warnings and instruc-
tions may result in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future refer-
ence.
19 Spindle
20 Inner flange
21 Outer flange
22 Vise plate
23 Vise nut
24 Vise handle
25 Limit mark
26 Screwdriver
27 Brush holder cap
WARNING Read all safety warnings and all
LC1230
75 mm x 150 mm
100 mm x 100 mm
85 mm x 85 mm
ENF100-1
GEA010-1
/II