Ferm TSM1032 Originalbetriebsanleitung Seite 9

to feed the workpiece further. Use at all times
the push stick for small workpieces.
• Switch off the saw bench when you have
sawed the workpiece.
Mitre guide
Fig. 6
The mitre guide (A) allows you to place the
workpiece on the table at an angle of 45° allowing
diagonal saw cuts to be made. You can for this
purpose secure the mitre guide to the guide (B)
(Fig. 6).
5. Maintenance
During maintenance and cleaning always
remove the mains plug from the socket.
Never use liquids when cleaning
electrical parts of the saw bench.
The machines have been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Malfunctions
The electric motor becomes hot.
• The motor is being overloaded by workpieces
that are too big.
• Saw at a lower speed so that the motor
can cool down.
• The ventilation grid of the motor is blocked.
• Clean the ventilation grid
• The motor is defective.
• Please contact the service address on the
warranty card.
The appliance does not work when
connected.
• The motor has been switched off by the
thermal cutout.
• Allow the applliance to cool down and
switch it on again.
• The mains connection has been broken.
• Check the mains connection for faults.
• The switch is damaged.
• Please contact the service address on the
warranty card.
It is very difficult to move the workpiece along
the saw blade in a straight line and the saw
cut is uneven.
• The saw blade is warped or blunt.
• Replace the saw blade.
• The rip fence is not properly secured.
• Clean the rip fence and secure it in the
correct way.
The workpiece starts to vibrate violently
during sawing.
• The saw blade is overheated or distorted.
• Replace the saw blade.
Maintain the saw bench on a regular
basis as this will prevent unnecessary
problems.
The following will ensure that your appliance
remains in optimum condition:
• Empty the dust-collection bin regularly. You
can remove the bin readily by loosening the
two attachment screws.
• Keep the saw blade clean to avoid
irregularities in the saw cut.
• Inspect the saw blade regularly for cracks,
fractures and broken or blunt teeth. Replace
damaged saw blades immediately.
• Keep the ventilation grid of the motor clean to
avoid the motor becoming overheated.
• Replace the inset piece when it is worn.
Cleaning
Keep the ventilation slots of the machine clean
to prevent overheating of the engine. Regularly
clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation
slots free from dust and dirt. If the dirt does not
come off use a soft cloth moistened with soapy
water. Never use solvents such as petrol, alcohol,
ammonia water, etc. These solvents may damage
the plastic parts.
Lubrication
The device does not need any additional
lubrication.
Defects
If a defect appears due to a part wearing out, please
contact the service center on the warranty card. At
the end of these instructions there is an exhaustive
overview of the parts that can be ordered.
Environment
EN
9