Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
12. Interlocking knob
13. Mitre guide
14. Nut
15. Screw
16. Spindle
2. safety instructions
Explanation of symbols
Denotes risk of personal injury, loss of
life or damage to the tool in case of non
observance of the instructions in this
manual.
Indicates the presence of an electrical
voltage.
Keep bystanders away.
Wear eye and ear protection.
Wear a dust mask protection
Before using the appliance
•
Make sure that the saw bench is adequately
and effectively illuminated.
•
When you use strip lighting you should be
aware of the so-called stroboscopic effect.
This may cause a rotating saw blade to
appear to be stationary. One solution is to use
two fittings in order to create
•
phase displacement.
•
Check the following points:
•
Does the voltage of the motor and any fuse
employed correspond with the mains voltage?
Appliances with a voltage of 230 V~ may be
connected without problems to a mains
voltage of 220 V~.
•
Are the feeder cable and plug in good
condition: sturdy, without loose bits or
damage?
•
Has the saw blade lost any teeth or is it
displaying cracks or fractures? If so, replace
the saw blade immediately.
•
The protective hood may not be set higher
than required to let the workpiece pass.
6
•
The riving knife should be narrower than the
saw cut and broader than the saw blade.
•
Do not exercise lateral pressure on the saw
blade as it may cause it to break.
•
Check the wood for knots, nails, cracks and
waste residues.
•
These irregularities may cause the workpiece
to kick back dangerously.
•
Ensure that no objects get into the extraction
system.
•
These objects may come into contact with the
saw blades resulting in potentially hazardous
situations.
Using the appliance
•
Push the workpiece that you are going to saw
securely to the table surface.
•
Hold at the same time the section of the
workpiece that has been sawed to prevent it
breaking off. The hand t hat secures the
sawed section should remain behind the saw
blade and move away from it. Make sure that
the hand that you use to secure the workpiece
does not cross the hand that you use to
operate the appliance.
•
Use the push stick supplied with the
appliance.
•
Use the push stick to guide smaller
workpieces past the saw blade.
•
Do not use long extension cables.
•
Allow the appliance to cool off before moving
it.
•
Do not remove wood residues in the vicinity of
the saw by hand.
•
When wood residues are trapped between
stationary and moving parts switch the
appliance off and remove the plug from the
electrical socket. Only then remove the
residues.
•
Select the appropriate saw blade.
•
Select the saw blade (with the correct teeth)
and the correct speed of rotation and slip
appropriate for the material to be sawed and
fit the saw blade carefully. This will not only
increase the lifetime of the saw blade but also
prevent cracks and fissures with their
attendant hazards. Fit only recommended
saw blades that meet European standard
EN847.
•
Do not saw pegs or sharp-cornered
workpieces.
•
This is hazardous. Saw pegs or sharp-
cornered workpieces with an appliance
Werbung
Inhaltsverzeichnis
