Klarstein DOLCE BACIO SMART Bedienungsanleitung Seite 32

EN
32
Start ice cream production
After setting the time or hardness level, press the START/PAUSE button to start
the set mode. The display stays on the whole time and counts down the set time.
When you have set the hardness level, the display starts counting up from 0. The
hardness bar flashes and grows from the left (soft) to the right (hard).
If you press the START/PAUSE button while the process is running, the stirring
motor pauses. The display shows the current remaining time. Press the START/
PAUSE button again to restart the current process.
• If you press the START/PAUSE button briefly during production, the motor
stops for 3 minutes. If you do not restart the process within 10 minutes, the
unit switches to standby mode and 3 short beeps sound.
• If you press and hold the START/PAUSE button during production, the machine
switches off and returns to the selected operating mode. If no other operation
is performed, the backlight turns off after 15 seconds.
• If you press the TIME button or the HARDNESS button during the break, you
can adjust the time and hardness level afterwards. However, the degree of
hardness can only be adjusted upwards.
After ice cream production
When production is finished, the machine automatically starts the keep-cool
function. [COOL] flashes on the display and the hardness level is measured. To
do this, the machine first stands still for 5 minutes, then the motor stirs for 15
seconds and then performs the hardness test.
• If the hardness is insufficient after test 1, the ice cream production continues.
• If the hardness is still insufficient at test 2, this cycle is continued for 120
minutes.
• If the hardness is sufficient, the keep-cool function is started automatically.
Keep-cool function
The keep-cool function prevents the finished ice cream from melting during your
absence. If the ice cream is ready and no one is operating the machine, the chilling
time is 120 minutes. After 120 minutes, the machine switches to standby mode.
The display shows [COOL] and the final hardness bar.