General Power Tool Safety Warnings; Work Area Safety - Parkside PMKA 20-Li A1 Originalbetriebsanleitung

OUTPUT
Rated voltage
Rated current
Charging time
Protection class
* BATTERY AND CHARGER ARE NOT SUPPLIED
Noise emission value
Noise measurement value determined in
accordance with EN 62841. The A-rated
noise level of the tool is typically
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Wear ear muffs!
Total vibration value
(vector total of three directions) determined in
accordance with EN 62841:
Cutting of sheet metal
Uncertainty
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with another
tool.
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
WARNING!
► Depending on the manner in which the power
tool is being used and, in particular, the kind
of workpiece being worked, the vibration and
noise emission values can deviate from the
values given in these instructions during
actual use of the power tool.
PMKA 20-Li A1
21.5 V (DC)
4.5 A
approx. 60 min
II / (double insulation)
L = 71.2 dB (A)
pA
K = 3 dB
pA
L = 82.2 dB (A)
WA
K = 3 dB
WA
a = 3.8 m/s
h
K = 1.5 m/s
WARNING!
► It is necessary to establish safety measures to
protect the operator based on an estimation
of the vibration load during actual use (all
states of operation must be included, e.g. times
when the power tool is switched off and times
where the power tool is switched on but
running without load).
General power
tool safety warnings
WARNING!
► Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
2
mains-operated (corded) power tool or battery-
2
operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can
cause you to lose control.
GB │ IE │ 3 ■