Assembly; Temperature Calibration; Resetting The Heater; Memory Function - Mill IB250 Bedienungsanleitung

6 millnorway.com

Assembly

See figure 2 on separate illustration sheet
A. Drill holes in the wall for holes 1 & 2. Then drill holes in the wall for the topmost holes
(holes 3 & 4 by using 6).
B. Insert the wall plugs into the drilled holes and attach the bracket with 4 screws.
C. Place the heater on the lower lugs on the bracket, then hang the heater on the
upper lugs (lift the heater slightly to align the heater with for the upper lugs). Screw in
the locking screws on the top of the bracket (clockwise).
ATTENTION! HORIZONTAL PLACEMENT ONLY

Temperature calibration

See figure 3 on separate illustration sheet
It may occur deviation between the temperature registered by the heater and the actual
temperature in the room. This can be caused by several reasons, however, the most com-
mon is that the heater is placed in a fair distance from where you usually reside. When you
set the temperature to for example 22 degrees, it is only natural that you expect the same
temperature where your sofa is placed for instance. However, the temperature sensor is
placed on the product itself, and therefore a deviation in temperature may occur. To adjust
this, all Mill heaters are equipped with a calibration function, which enables you to adjust
the temperature registered by the heater. N.B! The room must have achieved a stable
temperature before any calibration.
○
Press
○
firm with

Resetting the heater

See figure 4 on separate illustration sheet
Turn off the heater's main switch. Press and hold (9 while you turn on the heater's main
switch.

Memory function

The heater remembers all the temperature settings and will automatically return to the
desired temperature after a power cut. Your day- and nighttime setbacks will however be
deleted after a power cut, and you will need to register the programs again.

"Open window" function

The heater has an "open window" function that is activated instantly when it registers a
sudden drop in temperature with more than 2 degrees Celsius in 2 minutes. The heater will
automatically stop heating and FO will be visible in the display of the heater.
The heater will automatically start heating again after 10 minutes (the display switch from
FO to desired room temperature).
2 times and use + or - to set the actual temperature observed in the room. Con-
or wait 15 seconds for automatic confirmation.