Assembly; Temperature Calibration; Memory Function; Resetting The Heater - Mill SG1200WiFi Bedienungsanleitung

millheat.com

Assembly

See figure 3 on separate illustration sheet
1. The heater should be unplugged during assembly or disassembly.
2. Attach the legs to the brackets by tightening 2 screws into each bracket.
3. Remove the pre-mounted screws from the bottom of the heater and place the
heater gently on its head to mount the feet.
4. Two screws must be fastened on each foot bracket.
5. NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED.

Temperature calibration

See figure 4 on separate illustration sheet
It may occur deviation between the temperature registered by the heater and the
actual temperature in the room. This can be caused by several reasons, however, the
most common is that the heater is placed in a fair distance from where you usually
reside. When you set the temperature to for example 22 degrees Celsius, it is only natural
that you expect the same temperature where your sofa is placed for instance. However,
the temperature sensor is placed on the product itself, and therefore a deviation in
temperature may occur. To adjust this, all Mill heaters are equipped with a calibration
function, which enables you to adjust the temperature registered by the heater.
N.B! The room must have achieved a stable temperature before any calibration.
Press 2 times and use + or – to set the actual tempeature observed in the room.
WiFi
Confirm with or wait 15 seconds for automatic confirmation.
WiFi

Memory function

If the heater is connected to WiFi it will automatically reconnect with WiFi (where all
temperatures are saved) a er a power cut.

Resetting the heater

See figure 5 on separate illustration sheet
Turn o the heater's main switch. Press and hold
main switch.

"Open window" function

The heater has an «open window» function that is activated instantly when it registers a
sudden drop in temperature with more than 2 degrees Celsius in 2 minutes. The heater
will automatically stop heating and FO will be visible in the display of the heater.
The heater will automatically start heating again a er 10 minutes (the display switch
from FO to desired room temperature).
while you turn on the heater's
WiFi
5