Before First Use; First Use; Description Of Heater; Parts - Mill SG2000MEC Bedienungsanleitung

Before first use

After unpacking the heater, check to make sure the product was not damaged during
transport. Contact the retailer or importer if you discover any visible damages to the
product.
Keep the outer packaging to transport the heater in the future. If you want to dispose the
packaging, make sure it is done properly. Keep plastic bags away from children.

First use

After turning on the heater for the first time or after an extended period without use, the
heater can produce a burnt odor for a short time. This is normal.
Please read all the instructions carefully before use. Save the instruction manual for future
use.

Description of heater

Please see table above for which models that have mechanical/electronic thermostats.
A B
See figure 1 on separate illustration sheet
and Mechanical thermostat
1. Heat emission
2. Thermostat
3. Output selector
4. Legs (plastic)

Parts

A
See figure 2 on separate illustration sheet
Mechanical Thermost
• 4 screws (pre-mounted)
• 2 foot brackets
• 2 rails for the feet

Assembly

A
See figure 3 on separate illustration sheet
Mechanical Thermostat
1. Insert both legs into the brackets so you get a stable foot.
2. Remove the pre-mounted screws from the bottom of the heater and place the heater
gently on its head to mount the feet.
3. Two screws must be fastened on each foot bracket.
4. NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED.
C D E
, und Elektronisch Thermostat
1. Heat emission
2. LED display
3. Thermostat + output selector
4. Fan (does not apply to CO2200LEDMAX)
5. ON/OFF
6. Legs (aluminium)
B
Electronic Thermostat
• 8 screws (pre-mounted)
• 2 foot brackets
• 2 rails for the feet
5