Assembly; Temperature Calibration; Power Indicator; Resetting The Heater - Mill Gentle Air WiFi-Serie Bedienungsanleitung

millheat.com

Assembly

1. Remove the pre-mounted screws on both legs before you insert them into the
brackets, so that you get a stable foot.
2. Attach the legs to the brackets by tightening 2 screws into each bracket.
3. Remove the pre-mounted screws from the bottom of the heater and place the
heater gently on its head to mount the feet.
4. Two screws must be fastened on each foot bracket.
5. NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED.

Temperature calibration

It may occur deviation between the temperature registered by the heater and the
actual temperature in the room. This can be caused by several reasons, however, the
most common is that the heater is placed in a fair distance from where you usually
reside. When you set the temperature to for example 22 degrees, it is only natural that
you expect the same temperature where your sofa is placed for instance. However,
the temperature sensor is placed on the product itself, and therefore a deviation in
temperature may occur. To adjust this, all Mill heaters are equipped with a calibration
function, which enables you to adjust the temperature registered by the heater. N.B!
The room must have achieved a stable temperature before any calibration.
Press 2 times and use the wheel (+ or –) to set the actual temperature observed
in the room. Confirm with

Power indicator

When the heater is using power (i.e. when it is heating), the power indicator is lit

Resetting the heater

Turn off the heater´s main switch.Turn the heater back on, within 5 seconds press and
. After 20 seconds the display will show "Fr", once you see "Fr" release
hold
the heater will reset to factory settings.

"Open window" function

The heater has an «open window» function that is activated instantly when it registers a
sudden drop in temperature with more than 5 degrees Celsius in 15 minutes. The heater
will automatically stop heating and FO will be visible in the display of the heater.
While in open window mode, it will maintain 5°C (to avoid frost damage).
or wait 5 seconds for automatic confirmation.
5
.
and