How To Activate Daytime Setback; How To Activate Nighttime Setback - Mill IB250 Bedienungsanleitung

EXAMPLE:
Let us say you want to program the heater for both daytime- and nighttime setback (normally
the heater is set to 23 degrees). ‚bu want the heater to do the following:
1. Daytime setback activated from 7.30 am to 2.30 pm. Desired temperature: 17 degrees.
2. Nighttime setback activated from 10.00 pm to 6.00 am. Desired temperature: 18
degrees.

How to activate daytime setback

See figure 10 on separate illustration sheet
1. Tuesday 7.30 am you go to the heater and press
2. "d" will be visible in the display. Use the + and - buttons to set what day it is today
when you are programming the heater (1= Monday, 2 = Tuesday etc.) ‚bu are not pro-
gramming the heater for the various days. This is simply to tell the heater what day it is
when you are programming the heater. Select 2 for Tuesday. Confirm by pressing
3. "C" will flash in the display. Use the + and - buttons to set 17 as the desired temperatu-
re for daytime setback. Confirm by pressing
4. "H" will flash in the display. Use the + and - buttons to set 7 hours as desired setback
period (meaning it will be active from 7.30 am to 2:30 pm). Confirm by pressing
5. The daytime setback will now be active from 7.30 am to 2:30 pm every day. Setback
temperature is 17 degrees.
☉
*Control light is green when the heater is in an active setback period. The control light is
red when the setback period is inactive but programmed.

How to activate nighttime setback

See figure 11 on separate illustration sheet
1. Tuesday 10.00 pm you go to the heater and press
2. "d" will be visible in the display. Use the + and - buttons to set what day it is today
when you are programming the heater (l=Monday), 2 = Tuesday etc.). You are not
programming the heater for various days. This is simply to tell the heater what day it is
when you are programming the heater. Select 2 for Tuesday. Confirm by pressing
3. "C" will flash in the display. Use the + and - buttons to set 18 as the desirectfemperatu-
re for nighttime setback. Confirm by pressing
4. "H" will flash in the display. Use the + and - buttons to set 8 hours as desired setback
period (meaning it will be active from 22.00 pm to 6.00 am). Confirm by pressing
5. The nighttime setback will now be active from 10.00 pm to 6.00 am every day. The
setback temperature is 18 degrees.
*Control light(! is green when the heater is in an active setback period. The control light is red
when the setback period is inactive but programmed.
N.B! If a power cut occurs/you turn off the heater, the programming will be lost and you will
have to do this over again.
☉
on the heater's control panel.
○
☾
on the heater's control panel.
○
9
○
○
○
○