Herunterladen Inhalt Inhalt Diese Seite drucken

Assembly; Temperature Calibration; Memory Function; Resetting The Heater - Mill CO1200WIFI3 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für CO1200WIFI3:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 41
millnorway.com

Assembly

1. Remove the pre-mounted screws on both legs before you Insert the legs into the
brackets, so that you get a stable foot
2. Attach the legs to the brackets by tightening 2 screws into each bracket
3. Remove the pre-mounted screws from the bottom of the heater and place the
heater gently on its head to mount the feet.
4. Two screws must be fastened on each foot bracket
5. NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED

Temperature calibration

It may occur deviation between the temperature registered by the heater and the
actual temperature in the room. This can be caused by several reasons, however, the
most common is that the heater is placed in a fair distance from where you usually
reside. When you set the temperature to for example 22 degrees, it is only natural that
you expect the same temperature where your sofa is placed for instance. However,
the temperature sensor is placed on the product itself, and therefore a deviation in
temperature may occur. To adjust this, all Mill heaters are equipped with a calibration
function, which enables you to adjust the temperature registered by the heater. N.B!
The room must have achieved a stable temperature before any calibration.
Press
2 times and use + or – to set the actual temper

Memory function

If the heater is connected to WiFi it will automatically reconnect with WiFi (where all
temperatures are saved) after a power cut.

Resetting the heater

Turn off the heater's main switch. Turn the heater back on, within 5 seconds press and
hold
. After 20 seconds the display will show "Fr", once you see "Fr" release
heater will reset to factory settings.

"Open window" function

The heater has an "open window" function that is activated instantly when it registers a
sudden drop in temperature with more than 5 degrees Celsius in 15 minutes. The heater
will automatically stop heating and FO will be visible in the display of the heater.
15 seconds
ature observed in the room.
5
and the

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis