Kalor Denia 14 Bedienungsanleitung Seite 62

If the glass is broken, do not
attempt to light the stove.
Cleaning of ceramic coating (where present)
The ceramic coating must be cleaned with a soft, dry cloth.
Use only neutral and delicate detergents. Do not wet and
never clean the ceramic with cold water when it is hot: the
thermal shock may break it.
Be very
ceramic is hot.
Cleaning the surfaces
To clean the surfaces, use a rag dampened with water or
with water and a neutral detergent.
The use of aggressive detergents
or thinners can damage the
surfaces of the stove. Before
using any detergent it is advisable to try it
on a small section out of sight or contact
the Authorized Assistance Centre for
information regarding the product.
Cleaning the metal parts
To clean the metal parts of the stove, use a soft cloth
dampened with water.
Never clean the metal parts with alcohol, thinners, petrol,
acetone or other degreasing substances. If such substances
are used, our company declines any responsibility.
Eventual variations in the colour of the metal parts can be
caused by an incorrect use of the stove.
It is necessary to daily clean the
brazier and often clean the ash
box. The lack of cleanliness
can prevent the starting of the stove,
causing damages to the stove itself and
to the environment (possible emission of
unbrunt material and soot). Do not re-use
the pellet possibly remained in the brazier
due to no starting-up.
page 26 of 36
careful because
CLEANING BY THE TECHNICAL
Check every year
Clean the combustion chamber
When the stove is cold, please join the following procedure:
open the door and pull the ash tray out and remove the
brazier. (photo 1)
Remove the refractory fastening by pushing it upwards.
(photo 2)
the
Turn and tilt to remove it. (photo 3)
1 1
3 3
Now push the refractory upwards (photo 4 / photo 5), turn
it (photo 6) and remove it from the combustion chamber.
Handle the refractory carefully, it could break because it is
very fragile.
2 2
4 4