Cleaning The Glass - Kalor Denia 14 Bedienungsanleitung

Maintenance and cleaning of Mod. 14 - 14 C - 16 - 16 C
Before effecting any maintenance operation or cleaning on
the stove, take the following precautions:
• be sure that all parts of the stove are cold.
• be sure that the ashes are completely cold.
• be sure that the general switch is in the "OFF" position.
• be sure that the plug is pulled out of the socket to avoid
accidental contact.
• once the maintenance phase is completed check that
everything is in order as per before the intervention (the
brazier is placed correctly).
Follow carefully the following
cleaning instructions. Failure to
follow these instructions could
create problems with the operation of
the stove.
Cleaning the brazier and brazier support
When the flame assumes a red colour or seems weak, and
is accompanied by black smoke, this means that there are
ash deposits or incrustations that do not permit the correct
functioning of the stove and that must be removed. Remove
the brazier every day by simply raising it from its slot; then
clean out the ashes and eventual incrustations that may
have formed, paying particular attention to liberating the
holes by using a pointed tool (not included with the stove).
This operation is made particularly necessary before every
lighting the first several times and above all if using
pellets that differ from those supplied by our company. The
frequency of this operation is determined by how frequently
the stove is used and the choice of pellets.
It is also a good idea to check the brazier support, vacuuming
the eventual ash present.
Cleaning ash box
Open the door and extract the ash box. Use a vacuum to
remove all the ash deposited within.
This operation must be performed more or less frequently
depending on the quality of the pellets used.
Exchanger compartment cleaning
The exchanger compartment is located under the ash
drawer; clean the latter using an aspirator.

Cleaning the glass

The glass is a self cleaning type, therefore, while the stove
is working, a veil of air is blown across its surface to
remove ash and dirt; nevertheless over a period of several
hours, a greyish patina tends to form which should be
cleaned when the stove is next shut down. How dirty the
glass becomes also depends on the quality and quantity
of pellets used.
Cleaning the glass should be done when the stove is cold
with products recommended and tested by our company.
When performing this operation, always check that the
grey seal around the glass is in a good state; failure to
check the efficiency of this gasket can compromise the
function of the stove.
Poor quality pellets can, in any case, cause the glass to
become dirty.
page 25 of 36