Flex CSE 55 T Originalbetriebsanleitung Seite 27

CSE 55 T
Guide rail (optional).
A guide rail (800 or 1600 mm long) is available
from any FLEX customer service centre.
To extend the guide length, 2 guide rails
can be connected to each other.
To do this, a connector is available from any
FLEX customer service centre.
Fitting the connector:
 Remove protective caps from the guide
rails.
 Push connector halfway along the guide
rails.
 Clamp cams (4x).
"Sawing in" the guide rail:
klqb
_ÉÑçêÉ=ìëáåÖ=íÜÉ=ÖìáÇÉ=ê~áä=Ñçê=íÜÉ=Ñáêëí=íáãÉI=
Åìí=íÜÉ=~åíáJëéäáåíÉê=ëÜçÉ=íç=íÜÉ=êÉèìáêÉÇ=
ïáÇíÜK=fí=áë=êÉÅçããÉåÇÉÇ=íç=ìëÉ=~=åÉï=ë~ï=
Ää~ÇÉK
 Set mitre angle of 0°.
 Set cutting depth to 15 mm (1.).
 Place guide rail on a stable, level support
ensuring that the anti-splinter shoe
projects at the front.
 Switch on saw.
 Place saw with the inner guide groove
on the guide rail (2.).
 Feed saw evenly in the direction of the cut
as far as the end of the guide rail (3.).
27