Setting The Mitre Angle; Speed Control - Flex CSE 55 T Originalbetriebsanleitung

CSE 55 T

Setting the mitre angle

klqb
få=íÜÉ=Å~ëÉ=çÑ=ãáíêÉ=ÅìíëI=íÜÉ=ÅìííáåÖ=ÇÉéíÜ=
áë äÉëë=íÜ~å=íÜÉ=î~äìÉ=Çáëéä~óÉÇ=çå=íÜÉ=ëÅ~äÉ=
Ñçê=íÜÉ=ÅìííáåÖ=ÇÉéíÜK
 Pull out the mains plug.
 Loosen the T-screws (1.).
 Set required mitre angle with the aid
of the scale (2.).
 Tighten the T-screws (3.).
-1°-setting
klqb
_ó=éçëáíáçåáåÖ=íÜÉ=ë~ï=Ää~ÇÉ=~í=~=ëäáÖÜí=~åÖäÉI=
~=íÉ~êJÑêÉÉ=ìåÇÉêÅìí=áë=çÄí~áåÉÇ=çå=íÜÉ=ìåÇÉêJ
ëáÇÉë=çÑ=íÜÉ=Äç~êÇK=^ÑíÉê=íÜÉ=ìåÇÉêëáÇÉ=
çÑ=íÜÉ=Äç~êÇ=Ü~ë=ÄÉÉå=íìêåÉÇ=Ñ~ÅÉ=ìéI=íÜÉëÉ=
ìåÇÉêÅìíë=éêçÇìÅÉ=~=éÉêÑÉÅí=å~êêçï=Ö~é=
ïÜÉå=íÜÉó=ãÉÉíK
 Pull out the mains plug.
 Loosen toggle screws for the mitre
angle setting.
 Swing round both levers for -1° setting.
The selected setting becomes visible (-1°).
 Tighten the T-screws.
To reset to the 0° position:
 Loosen toggle screws for the mitre
angle setting.
 Swivel saw a little (~5°)
 Swing round both levers until "0°"
becomes visible.
 Swivel back saw bench.
 Tighten the T-screws.

Speed control

 The thumb wheel can be used to step-
lessly vary the speed from 1 (low)
to 6 (high) even while the power tool
is running.
As a result, the cutting speed can
be optimally adjusted to the particularly
material and to the working conditions.
25