Werock Scoria M240 Betriebsanleitung Seite 99

Setting the scanner scan rate
The speed of the barcode scanner of your device can be adjusted. Especially in combination with the
"Continuous Scanning" function, it can lead to undesired double scanning of barcodes. The scan interval can
be adjusted in millisecond increments (default value: 100). To set the scanner scan rate, do the following.:
1.
In the Scanner Configuration app, tap the gear icon in the upper right corner.
2.
Then tap on "General Settings".
3.
Now tap on "Scan interval" and enter the desired delay time in ms.
4.
Confirm the new behavior by tapping on "OK". The changes become active immediately.
Adjusting the LED brightness
The brightness of the barcode scanner from your device can be adjusted. This can be helpful if you regularly
work on reflective or luminous surfaces (e.g. displays) or your ambient light allows a lower illumination to
save battery. To adjust the LED brightness of your barcode scanner, do the following:
1.
In the Scanner Configuration app, tap the gear icon in the upper right corner.
2.
Then tap on "General Settings".
3.
tap on "Illumination power level" and enter a value between 0 (completely dark) and 10 (maximum
brightness).
Scoria M240 User Manual
99 / 120