Safety And Monitoring Equipment; Intended Use; Warranty - Werock Scoria M240 Betriebsanleitung

Safety and monitoring equipment

Intended use

Please use this device only as intended. Our devices are designed to be maintenance-free or low-
maintenance, so that normally no intervention by the end user is required. Please also note the operating
and storage temperatures stated in the technical data.
The Scoria M240 mobile computer is a hand-held electrical device. It is used for mobile data acquisition,
processing or radio transmission. It is used exclusively in combination with equipment that complies with
the requirements for overload category I. The permissible operating data of the device used must be
observed.
The device is not intended for use in private households.
The operator undertakes to allow only persons to work with the mobile computers who are

Are familiar with the basic regulations on safety and accident prevention and have been instructed in
the use of the mobile computer, and

Have read and understood the documentation, the safety chapter and the warnings.
The operator checks that the safety and accident prevention regulations applicable in each individual case
have been observed.

Warranty

Warranty period: 12 months
WEROCK warrants to the Buyer that all products are free from defects in material and workmanship for the
above period from the date of invoice.
Warranty claim
Warranty rights exist. A warranty claim can only arise with regard to the properties of the goods; reasonable
deviations in the aesthetic properties of the goods are not subject to the warranty claim. In the event of a
defect, WEROCK shall, at its option, provide subsequent performance in the form of rectification of the
defect or new delivery. The risk of accidental loss or deterioration of the goods shall pass upon delivery to
the person designated to transport the goods.
Scoria M240 User Manual
CAUTION
Risk of injury from glass and metal splinters
Bending or twisting could break the glass of the display, circuit
board or mechanics. If the glass is broken, do not attempt to
touch or remove any glass parts of the product.

Avoid operating the product with unsuitable styli.

Do not bend the product.

Do not use the product again until it has been replaced
by qualified service personnel.
73 / 120