Using The Barcode Scanner - Werock Scoria M240 Betriebsanleitung

Scoria M240 still require power in this mode as the operating system remains active, for example, to check
emails in the background or to receive calls.
Hint: If the user enters the PIN, password or pattern incorrectly five times, he must wait 30 seconds
before trying again. If the user forgets the PIN, password or pattern, contact the system administrator.

Using the barcode scanner

The device has an integrated high-performance barcode scanner from Zebra. With this reader, you can
electronically process 1D and 2D barcodes of all types. This section tells you how to activate, set up,
and use the barcode scanner.
Using the Barcode Scanner
To activate the barcode scanner, start the Scanner Configuration application. It must be running
permanently in the background for the scanning function to be active. Alternatively, a scan-enabled
application is required. It serves as an interface between the imager and the device. The integrated
barcode scanner in the Scoria M240 acts like a keyboard and can be triggered via the scan button. If
the scan is successful, a beep sounds in the standard configuration. However, the behavior can be
configured in the settings.
Make sure that an application is open on the device and a text field is in focus (text cursor in text
1.
field)
Aim the output window on the top of the device at a barcode.
2.
Press and hold the scan button, the red LED aiming pattern will light up to help with aiming.
3.
Scoria M240 User Manual
87 / 120