Werock Scoria M240 Betriebsanleitung Seite 95

Make settings for prefix or suffix
The scanner interface can extend your scan result with characters before the scan result (prefix) or after the
scan result (suffix). To add a prefix or suffix, do the following:
1.
In the Scanner Configuration app, tap the gear icon in the upper right corner.
2.
Then tap on "General Settings".
3.
now tap on "Prefix Content" or "Suffix Content" and enter the corresponding values.
Finally, confirm each entry by pressing "OK". The changes are applied immediately..
Configure action after barcode capture
After a successful scan, a control signal can still be attached to the barcode. There are three possibilities
for this.
1.
insert tabulator character before the barcode
2.
insert tabulator character after the barcode
3.
execute line break (Carriage Return / Enter) after the barcode
You can also combine tab and carriage return.
To make the settings, proceed as follows:
Insert tab character before or after the barcode
1.
In the Scanner Configuration app, tap the gear icon in the upper right corner.
2.
Then tap on "General Settings".
3.
then tap on "Tab" and select the desired property:
1.
"Add in front" adds a tab control character in front of the barcode
2.
"Add behind" adds a tab control character after the barcode
3.
"Close" does not add a tab control character barcode
4.
finally confirm the input by pressing "OK
Execute line break (Carriage Return / Enter) after the barcode
1.
in the Scanner Configuration app, tap the cogwheel icon in the upper right corner
2.
then tap on "General Settings
3.
now tap on the toggle switch at "Enter" so that it is highlighted in green.
Scoria M240 User Manual
95 / 120