Led Indicator - Werock Scoria M240 Betriebsanleitung

LED Indicator

Status
LED light off
LED light on
LED light flashing (1
sec. interval)
LED light flashing
(0.5 sec interval)
Pairing
1.
Make sure that Bluetooth is activated on your device. You can recognize this by the small Bluetooth
symbol next to the battery display. 2.
2.
Start the pairing mode of the Scan Trigger Handle by first pressing the Scan Trigger (2) and then the
on/off switch (1). The LED starts to flash quickly. Keep the Scan Trigger pressed until the LED
flashes more slowly. 3.
3.
Open the Bluetooth settings of your device and select "BLE_Handle". After successful connection,
the LED of the Scan Trigger Handle lights up continuously.
4.
Finally, the handle must be connected in the scanning app by activating the "Bluetooth Handle
Open" function under "Settings":
Scoria M240 User Manual
Meaning
The Scan Trigger Handle is not switched on
The Scan Trigger Handle is successfully connected to the device
The Scan Trigger Handle is switched on, but not yet successfully connected
to your device
The Scan Trigger Handle is in pairing mode and can be connected to a new
device.
93 / 120