Operating The Device; Standy Mode - Werock Scoria M240 Betriebsanleitung

8.
9. Now carefully slide the card holder back into the device.
10. Insert the battery again.
11. Place the battery cover back on the device and slide it up until it is back in its original position.
12. Lock the battery cover by sliding the locking mechanism to the right. Make sure the latch is pushed all
the way to the right.
Charge the device
1. To charge the device, you need the power supply unit and USB cable included in the scope of delivery.
2. Plug the USB cable into the designated socket of the device.
3. Connect the USB cable to the supplied power adapter.
4. Connect the power adapter to a power outlet. Make sure that it has the voltage specified in the technical
data.
5. As soon as the device is supplied with power and the battery is charged, the LED above the display
starts to light up red.
Note: Only use the supplied power supply to avoid malfunctions.
Start the device
Press the on/off switch for approx. 2 seconds. It takes a few seconds until a first display appears on the
screen.

Operating the device

In this chapter you will find general information on the operation of the device.

Standy Mode

The device goes into standby mode when the user presses the Power key or after a certain period of
inactivity (set in the Display Settings window).
To wake up the device from standby mode, press the Power key. The lock screen is displayed. Swipe up on
the screen to unlock it. When the pattern screen unlock feature is enabled, the pattern screen is displayed
instead of the lock screen. If the function to unlock the screen with PIN or password is enabled, enter the
PIN or password after unlocking the screen.
Scoria M240 User Manual
86 / 120