Werock Scoria M240 Betriebsanleitung Seite 96

Replacing characters
The software interface of your device can manipulate the output of the scanned barcode by exchanging
certain characters for others. This can be useful if the target application regularly requires a different code
format than is given.
To exchange a specific character, proceed as follows:
1.
In the Scanner Configuration app, tap the gear icon in the upper right corner.
2.
Then tap on "General Settings".
3.
Scroll down a bit until you reach the "Replace character" item and tap on it.
4.
Enter the original and target values that you want to replace and confirm the change by tapping on
"OK". The changes become active immediately.
Character encoding
The software interface of your device can transmit the scanned barcode in different encodings. Currently
supported character encodings are:

UTF-8

UTF-16

GBK

Big5

Shift_JIS (SJIS)

ISO/IEC 8859-15 (Latin-9)

US-ASCII

GB 18030
To adjust the character encoding, do the following:
1.
In the Scanner Configuration app, tap the gear icon in the upper right corner. 2.
2.
then tap on "General Settings
3.
scroll down a bit until you reach the item "Scan encoding" and tap on it.
Scoria M240 User Manual
96 / 120