SPORTSTECH DFX75 Bedienungsanleitung Seite 21

Step 3: Attach protective caps, insert batteries, attach display computer:
• Attach a protective cap (5) to each side of the bottom bracket axle (7.5). Screw them in with the edge of the
open-end wrench or with a wide flathead screwdriver.
• Open the battery compartment on the back of the display computer. Insert two AAA ("Micro", xR03) 1.5V
batteries. Refer to the symbols on the case to insert the batteries in the correct direction.
• Slide the computer onto the tab (6.1) on the mounting tube (2.1).
• Connect the sensor cable (6.2) of the display computer to the connector (7.6) on the main body (7).
5
• Check all connections for tightness.
Your trainer is now fully assembled
• You can adjust the height of the pedal straps just
before or during use.
6
6.1
6.2
2.1
8. CHAIR STOPPERS
• Use a suitable chair with your trainer. If you want to
use a chair with castors, secure it against rolling away
by placing stoppers under at least two of the castors.
21
7
7.5
6.2
7.6
EN