Extra Functions - elco AEROTOP SPLIT Bedienungsanleitung Für Den Betreiber

Scheduling

Extra functions

To set the programme for one of the
additional functions, press OK.
Turn the knob and select:
- Complete menu
Press the OK button.
Turn the knob and select:
- CH setting
Press the OK button.
Turn the knob and select:
- HOLIDAY FUNCTION (in heating
mode only)
The holiday function deactivates hea-
ting during holiday periods.
Press the OK button.
Turn the knob and select:
- ON (activates the function)
- OFF (deactivates the function)
Press the OK button.
If ON is selected, turn the knob to set
the date of return from the holidays.
This will enable the system interface to
resume operating - at the pre-set date -
in the previously set mode.
Press OK to save the settings; the
display will return to the previous
visualisation.
In the active sources page, when the
holiday function is active the "
icon appears.
Turn the knob and select:
- THERMOREGULATION
The Thermoregulation function auto-
matically sets the system's operating re-
gime based on the type of installation
and environmental conditions.
The temperature regulation of a buil-
ding consists in maintaining the indoor
temperature constant regardless of
variations in the outside temperature.
Press the OK button.
Turn the knob and select:
- ON (activates the function)
- OFF (deactivates the function)
Press OK to save the settings; the
display will return to the previous
visualisation.
In the active sources page, when the
SCI function is active the "SCI". icon
appears.
Room temperature adjustment with
SCI function active.
If the heating / cooling water tempera-
ture does not match the desired value,
it can be increased or decreased using
the "set heating temperature" or "set
cooling temperature" parameter.
The correction bar appears on the
display. Press OK to confi rm the setting,
or press the back button "" to return to
the previous screen without saving
The display visualises the correction
bar. Press OK to confi rm the correction,
or press the back button " " to return
to the previous visualisation without
saving the settings.
Turn the knob and select:
- SPECIAL FUNCTIONS
(where present)
This function limits the power of the
heat pump system to reduce the noise.
ATTENTION: The activation of this
function limits the maximum
power output of your heat pump to
approximately 70%, so that there may
be insuffi cient heating power.
Press the OK button.
Turn the knob and select:
"
- Quiet Mode Activation
- ON (activates the function)
- OFF (deactivates the function)
- Quiet Mode start time
(sets the activation time)
- Quiet Mode end time
(sets the deactivation time)
- PV Delta T DHW setpoint temp.
Thus function increases the do-
mestic water setpoint when extra
power is available from the photo-
voltaic system.
Press the OK button to confi rm the
selection.
Press the back button "
the previous screen.
Press the back button "
the previous screen.
- SYSTEM PERFORMANCE
you can see the energy performance of
the installed system.
Press the OK button.
Turn the knob and select:
- Complete Menu
Press the OK button.
Turn the knob and select:
- System performance
Press the OK button. Turn the knob and
select:
- Active sources
- Energy production
- Energy meteringg
- Reset Report
Press the OK button to confi rm your
selection.
- Active sources
Displays the energy produced by the
solar heating panel over 24 hours,
one week or one year.
- Energy production
Displays the energy produced by the
solar heating panel over 24 hours,
one week or one year.
- Energy metering
shows the estimated electricity con-
sumption in kW/h – in the domestic
water, heating and cooling modes –
over the past 4 months
ENERGY METERING
The energy consumption measu-
rement system integrated in this
product is based on an estimate.
Therefore, there may be diff erences
between the actual consumption (or
that measured by another system)
and the one displayed.
Turning the knob allows for selecting
the consumption data relative to one
of past four months.
- Consumptions history
This report shows the gas and electri-
city consumption histogram in kW/h
" to return to
based on the times selectable throu-
gh the knob (24h, weekly, monthly,
annual).
" to return to
Turn the knob to view:
- Heating mode consumption report
- Domestic water mode consumption
report
- Cooling mode consumption report
- Reset Report
Resets all reports.
31 / GB