5-Ghz-Band Vap (Virtual Access Point) - axing EOC 1-32 Betriebsanleitung

Operation instructions | EOC 1-32 and EOC 2-32 | Ethernet over Coax Peer to Peer

5.6. 5-GHz-Band VAP (Virtual Access Point)

5G VAP
In the window, you configure the parameters of the 5 GHz band.
Service
• Enable switches on the 5 GHz band.
SSID
• Disable switches off the 5 GHz band.
 Enter the name of your WIFI network here.
Security Mode
The name can be up to 15 characters long.
Define the security of your WIFI network here.
• Open:
• WPA-PSK/WPA2-PSK Mixed:
Pre-Shared Key
• WPA3
•
Specify a WIFI security key for the WIFI connection here.
•
Note: The pre-shared key must be at least 8 and at most 16 characters long and must not contain any
Cypher
special characters, only numbers and letters.
TKIP (Temporal Key Integrity Protocol) and CCMP (Counter Mode with Cipher Block Chaining Message
Authentication Code Protocol and AES (Advanced Encryption Standard) are encryption methods.
• Auto detects (depending on what the terminal device supports) either CCMP(AES) or TKIP.
• CCMP(AES), the Advanced Encryption Standard is used.
• TKIP, the Temporal Key Integrity Protocol is used.
 Click Update to apply the entered values.
Important: This does not yet activate the changes in the EOC. Only when you activate them on the
Changes
page will the changes actually be applied to the device (see 5.8 on page 21).
Page 18 of 26 AXING-BA_EOC-1-2-32.pdf | Technical improvements, changes in design, printing and other errors reserved. | 2022-08-16
No security
Wi-Fi-Protected-Acces with Pre-Shared-Key or
Wi-Fi-Protected-Acces with Pre-Shared-Key are used
depending on the terminal device.
End devices must support Wi-Fi Protected Access 3
Active