Network - axing EOC 1-32 Betriebsanleitung

Operation instructions | EOC 1-32 and EOC 2-32 | Ethernet over Coax Peer to Peer

5.3. Network

Operation Mode
NET
In the window, the
receives its IP address data from the DHCP server. The devices connected to the EOC also receive their IP
address data from the DHCP server.
 If you configure Bridge (Static IP) as the Operation Mode, additional fields are displayed. Enter the IP
address data of the EOC manually.
 Usually you also have to enter the IP address data of the connected devices manually.
 Click Update to apply the entered values.
Important: This does not yet activate the changes in the EOC. Only when you activate them on the
Changes
page will the changes actually be applied to the device (see 5.8 on page 21).
Page 14 of 26 AXING-BA_EOC-1-2-32.pdf | Technical improvements, changes in design, printing and other errors reserved. | 2022-08-16
is set to Bridge (DHCP Client) at factory. As a result, the EOC
Active